双激光脉冲打靶形成Gd等离子体的极紫外光谱辐射

高端芯片制造所需要的极紫外光刻技术位于我国当前面临35项"卡脖子"关键核心技术之首.高转换效率的极紫外光源是极紫外光刻系统的重要组成部分.本文通过采用双激光脉冲打靶技术实现较强的6.7 nm极紫外光输出.首先,理论计算Gd¹⁸⁺—Gd²⁷⁺离子最外层4d壳层的4p-4d和4d-4f能级之间跃迁、以及Gd¹⁴⁺—Gd¹⁷⁺离子最外层4f壳层的4d-4f能级之间跃迁对波长为6.7 nm附近极紫外光的贡献.其后开展实验研究,结果表明,随着双脉冲之间延时的逐渐增加,波长为6.7 nm附近的极紫外光辐射强度呈现先减弱、后增加、之后再减弱的变化趋势,在双脉冲延时为100 ns处产生的极紫外光辐射最强.并且,在延时为100 ns处产生的光谱效率最高,相比于单脉冲激光产生的光谱效率提升了33%.此外,发现双激光脉冲打靶技术可以有效地减弱等离子体的自吸收效应,获得的6.7 nm附近极紫外光谱宽度均小于单激光脉冲打靶的情形,且在脉冲延时为30 ns时刻所产生的光谱宽度最窄,约为单独主脉冲产生极紫外光谱宽度的1/3.同时...     

一种通过梯形PPMgLN波导倍频实现带宽可调谐光源的理论研究

本文设计了一种梯形的周期极化掺镁铌酸锂(PPMgLN)波导,并通过在传播方向上引入温度梯度来拓宽其倍频(SHG)过程的泵浦光源可接收带宽。通过有限差分的光束传输法,计算波导的有效折射率,并进行波导尺寸的设计。结果表明,通过改变梯形波导不同位置的温度,使其形成一个温度梯度,可拓宽泵浦光源的波长可接收带宽。本文所设计的PPMgLN波导最大泵浦光源可接收带宽为C波段,即1 530~1 565 nm,该波导可倍频C波段,得到输出波段带宽为765~782.5 nm,温度调谐范围为30~150 ℃。     

以磷化铁为添加剂沿(111)面生长磷掺杂金刚石大单晶

掺杂是调控金刚石性能的一种重要手段。本文采用温度梯度法,在5.6 GPa、1 312 ℃的条件下,选用Fe₃P作为磷源进行磷掺杂金刚石大单晶的合成。金刚石样品的显微光学照片表明,随着Fe₃P添加比例的增加,金刚石晶体的颜色逐渐变深,包裹体数量逐渐增加,晶形由板状转变为塔状直至骸晶。金刚石晶形的变化表明Fe₃P的添加使生长金刚石的V形区向右偏移,这是Fe₃P改变触媒特性的缘故。红外光谱分析表明,Fe₃P的添加使金刚石晶体中氮含量上升,这说明磷的进入诱使氮原子更容易进入金刚石晶格中。激光拉曼光谱测试表明,随着Fe₃P添加比例的增加,所合成的掺磷金刚石的拉曼峰位变化不大,其半峰全宽(FWHM)值变大,这说明磷的进入使得金刚石晶格畸变增加。XPS测试结果显示,随着Fe₃P添加比例的增加,金刚石晶体中磷相对碳的原子百分含量也会增加,这意味着添加Fe₃P所合成的金刚石晶体中有磷存在。     

A general framework for describing photofission observables of actinides at an average excitation energy below 30 MeV

A reasonable prediction of photofission observables plays a paramount role in understanding the photofission process and guiding various photofission-induced applications, such as short-lived isotope production, nuclear waste disposal, and nuclear safeguards. However, the available experimental data for photofission observables are limited, and the existing models and programs have mainly been developed for neutron-induced fission processes. In this study, a general framework is proposed for characterizing the photofission observables of actinides, including the mass yield distributions (MYD) and isobaric charge distributions (ICD) of fission fragments and the multiplicity and energy distributions of prompt neutrons (n_p) and prompt γ rays (γ_p). The framework encompasses various systematic neutron models and empirical models considering the Bohr hypothesis and does not rely on the experimental data as input. These models are then validated individually against experimental data at an average excitation energy below 30 MeV, which shows the reliability and robustness of the general framework. Finally, we employ this framework to predict the characteristics of photofission fragments and the emissions of prompt particles for typical actinides including ²³²Th, ^{235, 238}U and ²⁴⁰Pu. It is found that the ²³⁸U(γ, f) reaction is more suitable for producing neutron-rich nuclei compared to the ²³²Th(γ, f) reaction. In addition, the average multiplicity number of both n_p and γ_p increases with the average excitation energy.     

雾化辅助化学气相沉积法氧化镓薄膜生长研究

采用自主设计搭建的雾化辅助化学气相沉积系统设备,开展了Ga₂O₃薄膜制备及其特性研究工作。通过X射线衍射研究了沉积温度、系统沉积压差对Ga₂O₃薄膜结晶质量的影响。结果表明,Ga₂O₃在425~650 ℃温度区间存在物相转换关系。随着沉积温度从425 ℃升高至650 ℃,薄膜结晶分别由非晶态、纯α-Ga₂O₃结晶状态向α-Ga₂O₃、β-Ga₂O₃两相混合结晶状态改变。通过原子力显微镜表征探究了生长温度对Ga₂O₃薄膜表面形貌的影响,从475 ℃升高至650 ℃时,薄膜表面粗糙度由26.8 nm下降至24.8 nm。同时,高分辨X射线衍射仪测试表明475 ℃、5 Pa压差条件下的α-Ga₂O₃薄膜样品半峰全宽仅为190.8″,为高度结晶态的单晶α-Ga₂O₃薄膜材料。     

Hudson模型适用性及储层微观建模应用*

为明确裂缝间相互作用对各向异性的影响，本文以Hudson模型为例分析了裂缝密度、裂缝倾角对地震波波场、弹性常数和Thomsen系数的影响规律，然后采用“基质-骨架-流体”组合化的方法进行了裂缝储层微观尺度的建模，并与实际测井资料进行了对比。结果表明该模型适用条件为低裂缝密度储层，二阶模型适用的裂缝密度范围比一阶模型大，但在裂缝密度过大时，二阶模型会出现不收敛的现象，模型便不再适用。裂缝储层纵横波速度随裂缝倾角增大而增大，纵波速度对裂缝倾角更为敏感。另外，在与实际测井曲线对比时，在高裂缝密度地层二阶模型的应用效果明显优于一阶模型，说明了在高裂缝密度储层考虑裂缝间的相互作用的必要性。     

One Spot Microwave Synthesis and Characterization of Nitrogen-Doped Carbon Dots with High Oxygen Content for Fluorometric Determination of Banned Sudan II Dye in Spice Samples

Journal of Fluorescence - A simple microwave-assisted synthesis of nitrogen-doped carbon dots with high oxygen content (O-N-CDs) was carried out with citric acid as a carbon source and...